QC Release Powder II
Look below for some helpful tips so you can use QC Release Powder II to its fullest
- Make sure the sub-grade is prepared as required as for any concrete slab
- Tamp and/or vibrate concrete (be careful not to overwork material), screed,
then wood float to finished grade.
- While QC Release Powder II may be used on vertical faces of step risers, curbs,
etc., it is not practical for use on large areas of vertical surfaces.
- QC Release Powder II should remain in a dry state on the concrete surface,
and should not be worked into the surface. Care should be taken not to trowel
the release powder into the wet concrete.